XV535 - Setting float levels on the
bench |
Description Initial bench set up Author coalstoves Date Tue Jul 07, 2009 4:29 pm Type Tech Article Keywords Category Tech Tips Comments [0 - Post your comments] Views 158 [Rate Article] |
For the
XV535 (Initial bench set up never to be
substituted for final adjustment via the tube) See the shape of the float and that casting mark circle on the jet block? When the float height is set correctly, the edge of the float will be exactly the same as the casting mark, like the edge of a circle on the edge of another circle. The carb on the right is set rich, and the one on the left is set lean, but close to where it should be (see the circular casting mark?) Here it's set just right. |